advertisingwqp.blogg.se

Camshaft Synchronizer - 3.0L, 4.0LĪlign the synchronizer vane with the radial slot of the Syncro Positioning Tool T95T-12200-A (3.0L). Remove camshaft synchronizer from cylinder blocks.Īttach Syncro Positioning Tool T95T-12200-A (3.0L, 4.0L). If the camshaft synchronizer is not being removed, proceed to installation Step 8. NOTE: If camshaft synchronizer is to be removed from the cylinder blocks (6010), proceed with Step 4. Doing so will result in the fuel system being out of time with the engine resulting in possible emissions fault. Remove the CMP sensor screws and camshaft position sensor from camshaft synchronizer.ĬAUTION: Do not move crankshaft (6303) until entire installation procedure is complete. The installation procedure requires that the electrical connector be located in the same position.ĭisconnect fuel charging wiring electrical connector from camshaft position sensor. Then note the position of the camshaft position sensor electrical connector. 1 cylinder to 0 degrees top dead center (TDC) of compression stroke. Failure to follow this procedure will result in the fuel system being out of time with the engine (6007), possibly causing engine damage.ĬAUTION: Prior to the removal of the camshaft position sensor (CMP sensor) (12A112), set No. SPECIAL SERVICE TOOL(S) REQUIRED DescriptionĬAUTION: Syncro Positioning Tool T95T-12200-A (3.0L, 4.0L) must be obtained prior to installation of the replacement synchronizer assembly. SteveĬamshaft Position (CMP) Sensor - 3.0L and 4.0L Without the tool, it is just not possible to know that it is exact. It may or may not turn on the check engine lamp and set a cam sensor code, depending on how close you are with it. If you can put both engines on TDC compression on #1 and place the synchronizer in the replacement engine at as close to the setting it was in on the original, it will run okay, but the fuel injection timing will be off slightly. The only place I know of to get the tool is a Ford dealer as it is not commonly available at parts stores. Before you set out to change it, there is a special procedure and a special alignment tool needed. as they are different, it will mistrigger the cam sensor. Yes, you do need to change the synchronizer asy.